HP LaserJet Enterprise 600 Printer M603 series - Install internal USB devices

background image

Install internal USB devices

The product has two internal USB ports.

1.

Turn the product off.

2.

Disconnect the power cord and interface cable.

3.

Remove the right-side panel by sliding it towards the rear of the product to unlatch it.

ENWW

Install memory and internal USB devices

163

background image

4.

Open the access door by pulling on the metal tab.

5.

Locate the USB ports near the bottom of the formatter board. Insert the USB device into one of the

ports.

CAUTION:

To prevent static electricity from damaging the formatter board, hold the metal

access door with one hand while you insert the USB device with the other hand. If you move away

from the product during this procedure, be sure to touch the metal access door to discharge

electricity before continuing.

6.

Close the access door, and press firmly until it snaps into place.

164

Chapter 9 Manage and maintain

ENWW

background image

7.

Reinstall the right-side panel. Align the tabs on the panel with the slots in the product, and push the

panel toward the front of the product until it latches into place.

8.

Reconnect the interface cable and the power cord.

9.

Turn the product on.

ENWW

Install memory and internal USB devices

165