Install internal USB devices
The product has two internal USB ports.
1.
Turn the product off.
2.
Disconnect the power cord and interface cable.
3.
Remove the right-side panel by sliding it towards the rear of the product to unlatch it.
ENWW
Install memory and internal USB devices
163
4.
Open the access door by pulling on the metal tab.
5.
Locate the USB ports near the bottom of the formatter board. Insert the USB device into one of the
ports.
CAUTION:
To prevent static electricity from damaging the formatter board, hold the metal
access door with one hand while you insert the USB device with the other hand. If you move away
from the product during this procedure, be sure to touch the metal access door to discharge
electricity before continuing.
6.
Close the access door, and press firmly until it snaps into place.
164
Chapter 9 Manage and maintain
ENWW
7.
Reinstall the right-side panel. Align the tabs on the panel with the slots in the product, and push the
panel toward the front of the product until it latches into place.
8.
Reconnect the interface cable and the power cord.
9.
Turn the product on.
ENWW
Install memory and internal USB devices
165